Skip to main content

Nobody daydreams about speaker stands. Yet the unglamorous furniture holding your system routinely makes a bigger audible difference than upgrades costing five times as much — and it is one of the few areas where the physics is refreshingly simple.

Close-up of a loudspeaker bass driver

Speakers: stop the cabinet dancing

A loudspeaker works by moving air precisely. If the cabinet rocks on a wobbly surface, that precision smears — bass softens, images blur. Standmount speakers need proper stands: rigid, the right height (tweeters near ear level), with the speaker firmly coupled on top. A bookshelf is where the name came from, not where the performance lives.

Spikes, pads and the floor question

Spikes anchor stands and floorstanders through carpet to the solid floor beneath. On suspended timber floors that can transmit boom instead — isolation pads under the spikes often work better. Rule of thumb: couple to solid, isolate from bouncy, and listen to which your room prefers.

Getting stand height and position right

Sit where you normally listen and measure from the floor to your ear: the tweeter wants to be close to that height, which for most sofas means a stand of around 60cm. The top plate should be no bigger than the base of the speaker, and the speaker should be fixed to it — a few small blobs of reusable putty or the pads supplied with the stand do the job, and stop a nudge from a child or a vacuum cleaner ending in tears.

Then position. Start with the speakers 30 to 50cm clear of the wall behind them and angled so they point just past your shoulders. Closer to the wall gives more bass and less definition; further out does the reverse. Move them a hand’s width at a time and listen — it costs nothing and it is the most effective tuning there is.

Filling the stands

Many stands have hollow columns, and an empty steel tube rings like a bell when tapped. Filling it with dry sand or a purpose-made filler adds mass and deadens the ring. Go in stages rather than to the brim: part-filled often sounds better than full, and you can always add more.

Floorstanders: the common mistakes

Fit the outrigger feet or plinth that came in the box — they are there for stability, not decoration. Adjust the spikes until all four carry weight and the cabinet cannot rock when you press a top corner. On a wooden floor, spike shoes or a coin under each spike saves the boards. On a bouncy suspended floor, a paving slab or a stone chopping board under each speaker is an inexpensive platform that often tightens the bass more than any accessory. And keep loudspeakers off the surface the turntable sits on: the stylus cannot tell music from furniture vibration.

Electronics: rigid beats ornamental

Turntables care enormously about what they sit on (see our setup guide); amplifiers mostly want rigidity and ventilation. A purpose-built rack like the Blok furniture we stock provides both without the wobble of decorative units — and looks after cable routing too.

Where the money stops mattering

Beyond rigid, level and well-ventilated, returns diminish quickly. Exotic isolation is a refinement for resolving systems, not a rescue for shaky foundations — foundations first, always.

Feel the difference

The stands demonstration is our favourite party trick: the same speakers on a shelf, then on proper stands. Thirty seconds settles it — arrange a visit and hear what the furniture was hiding.

Found this guide useful, or got questions? We’re happy to talk it through — no hard sell, just straight answers. Contact us or call 01743 234945.

Book a Call with Duncan

Call Us Arrange a Demo