Few subjects divide hi-fi people like room correction. To some, software like Dirac Live is the most significant advance in decades; to others it’s heresy — a computer “fiddling” with the signal purists spend fortunes keeping pure. We stock equipment with it built in, so here is our honest position.

In this guide
What Dirac Live actually does
Using a microphone, it measures how your room mangles what the speakers produce — and every room does, especially in the bass, where peaks and dips of ten decibels or more are common. It then applies precise, measured corrections so what reaches your ears is closer to what was recorded. It is not an effect or a tone control; it is an apology on your room’s behalf.
The case against
Purists argue correction treats symptoms: fix the room, position the speakers properly, and you need less of it. They are not wrong — no software rescues a poor setup, and correction applied heavy-handedly above the bass can drain life from a system. Our room acoustics guide and careful placement remain the foundations.
The case for
Real rooms have sofas where absorbers should be and doorways where speakers ought to stand. Below about 300Hz, no amount of furniture shuffling fixes physics — and that is exactly where Dirac is at its best. Used judiciously, bass tightens, the midrange clears, and the system finally sounds like it did in the showroom.
What setting it up involves
Less than people fear. A small measurement microphone goes where your head normally is, then at a handful of positions around it, with the app showing you where to put it each time. At each position the system plays a short sweep through each loudspeaker and listens to what comes back. Allow half an hour in a quiet house. The software then shows you what your room is doing, proposes a correction, and lets you adjust the target — the tonal balance it is aiming for — before you save it. Most equipment stores several versions, so you can switch between them from your chair.
Getting the best from it
Do the free work first: place the speakers properly, then measure with the room as you really use it — curtains where they normally hang, doors as they normally stand. If the result sounds a little lifeless, limit the correction to the bass and lower midrange and leave the rest alone; the software lets you set the range, and many listeners end up happiest that way. Aim for a gentle downward tilt towards the treble rather than a ruler-flat line, which tends to sound bright. And measure again if the furniture or the speakers move — the correction belongs to one arrangement of one room.
What it cannot do
It cannot shorten the echo of a bare, lively room: that takes rugs and curtains. It cannot make a small loudspeaker produce bass it was never built for. It cannot fill a deep cancellation, because pouring power into a hole in the response only works the amplifier harder. And it is optimised for the area you measured, so the best seat gains the most. Seen for what it is — a precise tool for the bass problems every room has — it is easy to recommend. Seen as a cure for everything, it will disappoint.
Hear it switched in and out
Arcam builds Dirac Live into its streaming amplifiers — the SA35 and flagship SA45 we stock — and the acid test takes thirty seconds: same track, correction on, correction off. Arrange a demonstration and judge the controversy with your own ears; we’ll happily play devil’s advocate on both sides.
Found this guide useful, or got questions? We’re happy to talk it through — no hard sell, just straight answers. Contact us or call 01743 234945.


